Easy Installation
Note: Test fit frame prior to installing lights in frame.
1. Measure window from sill to top window jamb (A). Remove rubber end-cap. Cut lengths to apprximately 1/8 inch less than window vertical dimension (A) - necessary to allow for rubber end caps. After cutting, replace caps.
2. Build your frames in your windows by friction fitting left and right lengths in window. Notches should face indoors. Note: caps may be used to compensate for slight measuring/cutting errors.
3. Cut horizontal supports. Horizontal dimension should be the distance between the vertical rods plus 3"(B) allowing for 1½" to extend on each side.
4. Snap knob of horizontal support into notch of vertical length.
5. Remove frame from window and place on table or floor. Slide miniature lights into notches Make sure plug is at the bottom of frame.
6. Place frame in window between sill(C) and top window jamb(D) with notches (lights) facing indoors (away from glass).
7. Made of durable plastic.
Installation Hints:
1. Remove and store intact with lights on frame for quick installation next year.
2. For picture windows, assemble several small frames.
3. For windows without sills, it may be necessary to hang. Install hook(s) to top of window
frame as necessary.
4. For windows with blinds, it may be necessary to horizontally mount and/or install with lights
facing glass.
5. Lights with ornaments should be wrapped around Window Wonder frame.
To place an order call Toll Free 1.877.807.0016 in the US and Canada
Window Wonder
211 Ladner Avenue Buffalo, N.Y. 14220-2143
To place an order call Toll Free 1.877.807.0016 in the U.S and Canada www.window-wonder.com
To print this please click file/print